Letteratura scientifica selezionata sul tema "Stationary scanner"
Cita una fonte nei formati APA, MLA, Chicago, Harvard e in molti altri stili
Consulta la lista di attuali articoli, libri, tesi, atti di convegni e altre fonti scientifiche attinenti al tema "Stationary scanner".
Accanto a ogni fonte nell'elenco di riferimenti c'è un pulsante "Aggiungi alla bibliografia". Premilo e genereremo automaticamente la citazione bibliografica dell'opera scelta nello stile citazionale di cui hai bisogno: APA, MLA, Harvard, Chicago, Vancouver ecc.
Puoi anche scaricare il testo completo della pubblicazione scientifica nel formato .pdf e leggere online l'abstract (il sommario) dell'opera se è presente nei metadati.
Articoli di riviste sul tema "Stationary scanner"
Rabah, Chaima Ben, Gouenou Coatrieux e Riadh Abdelfattah. "Boosting up Source Scanner Identification Using Wavelets and Convolutional Neural Networks". Traitement du Signal 37, n. 6 (31 dicembre 2020): 881–88. http://dx.doi.org/10.18280/ts.370601.
Testo completoDlesk, A., K. Vach, J. Šedina e K. Pavelka. "COMPARISON OF LEICA BLK360 AND LEICA BLK2GO ON CHOSEN TEST OBJECTS". International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences XLVI-5/W1-2022 (3 febbraio 2022): 77–82. http://dx.doi.org/10.5194/isprs-archives-xlvi-5-w1-2022-77-2022.
Testo completoWerner, Christoph S., Jannis Gangelhoff, Simon Frey, Daniel Steiger e Alexander Reiterer. "Development of a compact pulsed time-of-flight LiDAR platform for underwater measurements". International Hydrographic Review 29, n. 2 (1 novembre 2023): 200–207. http://dx.doi.org/10.58440/ihr-29-2-n09.
Testo completoJafri, Syed Riaz un Nabi, Muhammad Owais Ali Siddiqui, Faraz Akbar, Abdul Basit, Sheraz Shamim e Saad Ahmed. "Development of a Low-Cost Stationary Laser Scanning System for Generation of Building Information Models". Elektronika ir Elektrotechnika 28, n. 6 (21 dicembre 2022): 12–20. http://dx.doi.org/10.5755/j02.eie.31374.
Testo completoVoges, R., C. S. Wieghardt e B. Wagner. "TIMESTAMP OFFSET DETERMINATION BETWEEN AN ACTUATED LASER SCANNER AND ITS CORRESPONDING MOTOR". ISPRS Annals of Photogrammetry, Remote Sensing and Spatial Information Sciences IV-1/W1 (30 maggio 2017): 99–106. http://dx.doi.org/10.5194/isprs-annals-iv-1-w1-99-2017.
Testo completoXia, Sibei, Siming Guo, Jiayin Li e Cynthia Istook. "Comparison of different body measurement techniques: 3D stationary scanner, 3D handheld scanner, and tape measurement". Journal of The Textile Institute 110, n. 8 (26 dicembre 2018): 1103–13. http://dx.doi.org/10.1080/00405000.2018.1541437.
Testo completoDixon, Robert L., e John M. Boone. "Stationary table CT dosimetry and anomalous scanner-reported values of CTDIvol". Medical Physics 41, n. 1 (18 dicembre 2013): 011907. http://dx.doi.org/10.1118/1.4845075.
Testo completoO, Gavrylenko, Zhdanova O, Nazirov R, Parkhomenko D, Shumeyko O e Khalus O. "DETERMINATION OF STATIONARY TANK CAPACITY ACCORDING TO LASER SCAN RESULTS". National Transport University Bulletin 1, n. 51 (2022): 84–94. http://dx.doi.org/10.33744/2308-6645-2022-1-51-084-094.
Testo completoMoon, Seunghwan, Jaekwon Lee, Joho Yun, Juhun Lim, Min-Joo Gwak, Kyung-Su Kim e Jong-Hyun Lee. "Two-Axis Electrostatic Gimbaled Mirror Scanner With Self-Aligned Tilted Stationary Combs". IEEE Photonics Technology Letters 28, n. 5 (1 marzo 2016): 557–60. http://dx.doi.org/10.1109/lpt.2015.2513483.
Testo completoAlekseev, N. Yu, e P. V. Zyuzin. "Assessment of Applicability of Wi-Fi Analytics in Studies of Urban Public Transport Passenger Flow (Moscow Case Study)". World of Transport and Transportation 19, n. 3 (2 dicembre 2021): 54–66. http://dx.doi.org/10.30932/1992-3252-2021-19-3-6.
Testo completoTesi sul tema "Stationary scanner"
Laurendeau, Matthieu. "Tomographic incompleteness maps and application to image reconstruction and stationary scanner design". Electronic Thesis or Diss., Lyon, INSA, 2024. http://www.theses.fr/2024ISAL0130.
Testo completoComputed tomography (CT) is one of the most commonly used modality for three-dimensional (3D) imaging in the medical and industrial fields. In the past few years, new X-ray sources have been developed based on carbon nanotube (CNT) cathodes. Their compact size enables the design of a new generation of multi-source CT scanners. In contrast to traditional systems with a single moving source, these scanners often adopt stationary architectures where multiple sources are static. It would benefit both industry with cheaper and motionless systems and medical applications with light-weight and mobile scanners which could be brought to emergency sites. However, this type of scanner uses a fewer number of measurements, known as projections, and may acquire data with a limited range of angles, leading to well-known image reconstruction challenges. This thesis focuses on the design of such stationary CT scanners. Three axes of study were investigated. The first contribution is the development of an object-independent metric to assess the reconstruction capability of a given scanning geometry. Based on Tuy's condition, the metric evaluates local tomographic incompleteness and is visualized through 3D vector field maps. It is further extended to handle truncated projections, improving its applicability to real-world configurations. The metric enables ranking different geometries, predicting image quality reconstruction, and identifying the origin of geometric artifacts. It is applied to a variety of geometries, including existing scanners. The second is a novel local regularization method to address limited-angle reconstruction challenges. The method employs a directional total variation (DTV) regularizer whose strength and directional weights are adaptively selected at each voxel. The weights are determined based on the previously introduced metric. Two approaches for directional weights were explored: ratio-based weighting relative to image axes and ellipse-based weighting. The reconstruction algorithm is evaluated in both 2D and 3D simulations, considering noiseless and noisy data, as well as real data. The third is a tool for optimizing the geometry of CT scanners. Given a fixed number of sources and the surface area available for their positions, the tool optimizes the placement of sources based on the proposed metric. Several state-of-the-art optimization algorithms were implemented and tested on simple 2D and 3D scenarios
Yang, Guang Zhou Otto. "Carbon nanotube based stationary X-ray tomosynthesis scanner for detection of breast cancer". Chapel Hill, N.C. : University of North Carolina at Chapel Hill, 2008. http://dc.lib.unc.edu/u?/etd,1874.
Testo completoTitle from electronic title page (viewed Dec. 11, 2008). "... in partial fulfillment of the requirements for the degree of Doctor of Philosophy in the Department of Physics and Astronomy." Discipline: Physics and Astronomy; Department/School: Physics and Astronomy.
Mulè, Leonardo. "Low-cost survey solutions to support HBIM - Two case studies: the Azurém Canteen and Paço dos Duques in Portugal". Master's thesis, Alma Mater Studiorum - Università di Bologna, 2022.
Cerca il testo completoLibri sul tema "Stationary scanner"
Wang, Sigen, Otto Zhou e Sha Chang. Carbon-nanotube field emission electron and X-ray technology for medical research and clinical applications. A cura di A. V. Narlikar e Y. Y. Fu. Oxford University Press, 2017. http://dx.doi.org/10.1093/oxfordhb/9780199533060.013.19.
Testo completoCapitoli di libri sul tema "Stationary scanner"
Dixon, Robert L. "Stationary Table CT Dosimetry and Anomalous Scanner-Reported Values of CTDI vol". In The Physics of CT Dosimetry, 191–204. Boca Raton, FL : CRC Press, Taylor & Francis Group, [2019] | Series: Series in medical physics and biomedical engineering: CRC Press, 2019. http://dx.doi.org/10.1201/9780429023330-9.
Testo completoAllegra, Dario, Giovanni Gallo, Laura Inzerillo, Marcella Lombardo, Filippo L. M. Milotta, Cettina Santagati e Filippo Stanco. "Hand Held 3D Scanning for Cultural Heritage". In Advances in Religious and Cultural Studies, 475–99. IGI Global, 2017. http://dx.doi.org/10.4018/978-1-5225-0675-1.ch016.
Testo completoSamoilenko, Oleksandr, e Volodymyr Zaets. "Calibration of Tanks and Ships’ Tanks for Storage and Transportation of Liquids by Laser Scanning". In Applied Aspects of Modern Metrology [Working Title]. IntechOpen, 2021. http://dx.doi.org/10.5772/intechopen.100565.
Testo completoAtti di convegni sul tema "Stationary scanner"
Schermer, Mack J. "Stationary platen 2-axis scanner". In SPIE Proceedings, a cura di Leo Beiser e Gerald F. Marshall. SPIE, 1991. http://dx.doi.org/10.1117/12.28038.
Testo completoQian, Xin, Andrew Tucker, Emily Gidcumb, Jianping Lu, Otto Zhou, Derrek Spronk, Frank Sprenger et al. "A stationary digital breast tomosynthesis scanner". In SPIE Medical Imaging, a cura di Norbert J. Pelc, Robert M. Nishikawa e Bruce R. Whiting. SPIE, 2012. http://dx.doi.org/10.1117/12.911540.
Testo completoSpronk, Derrek, Yueting Luo, Christina R. Inscoe, Otto Zhou, Jianping Lu e Yueh Z. Lee. "Stationary head CT scanner using CNT x-ray source arrays". In Physics of Medical Imaging, a cura di Hilde Bosmans, Wei Zhao e Lifeng Yu. SPIE, 2021. http://dx.doi.org/10.1117/12.2581093.
Testo completoKatsevich, Alexander, Seongjin Yoon, Michael Frenkel, Ed Morton e Will Thompson. "Reduction of irregular view-sampling artifacts in a stationary gantry CT scanner". In The Fifteenth International Meeting on Fully Three-Dimensional Image Reconstruction in Radiology and Nuclear Medicine, a cura di Samuel Matej e Scott D. Metzler. SPIE, 2019. http://dx.doi.org/10.1117/12.2534878.
Testo completoSpronk, Derrek, Yueting Lu, Christy Inscoe, Alex Billingsley, Yueh Z. Lee, Jianping Lu e Otto Zhou. "Feasibility of a stationary head CT scanner using a CNT x-ray source array". In Physics of Medical Imaging, a cura di Hilde Bosmans e Guang-Hong Chen. SPIE, 2020. http://dx.doi.org/10.1117/12.2549335.
Testo completoLiu, Hui, Jing Wu, Si Chen, Shi Wang, Yaqiang Liu e Tianyu Ma. "Development of stationary dedicated cardiac SPECT with multi-pinhole collimators on a clinical scanner". In 2015 IEEE Nuclear Science Symposium and Medical Imaging Conference (NSS/MIC). IEEE, 2015. http://dx.doi.org/10.1109/nssmic.2015.7582154.
Testo completoDion, Scott, e Akin Tatoglu. "ROS Based Adjustable Resolution Compact 3D Scanner". In ASME 2019 International Mechanical Engineering Congress and Exposition. American Society of Mechanical Engineers, 2019. http://dx.doi.org/10.1115/imece2019-11892.
Testo completoDraelos, Mark, Pablo Ortiz, Ruobing Qian, Brenton Keller, Kris Hauser, Anthony Kuo e Joseph Izatt. "Automatic Optical Coherence Tomography Imaging of Stationary and Moving Eyes with a Robotically-Aligned Scanner". In 2019 International Conference on Robotics and Automation (ICRA). IEEE, 2019. http://dx.doi.org/10.1109/icra.2019.8793524.
Testo completoPeng, R., J. Zhang, X. Calderon-Colon, S. Wang, S. Sultana, S. Chang, J. P. Lu e O. Zhou. "Stationary micro-CT scanner using a distributed multi-beam field emission x-ray source: a feasibility study". In SPIE Medical Imaging, a cura di Ehsan Samei e Jiang Hsieh. SPIE, 2009. http://dx.doi.org/10.1117/12.811467.
Testo completoYan Xia, Tianyu Ma, Xiao Deng, Yaqiang Liu, Yongjie Jin, S. Murali e Rutao Yao. "A hybrid rotation-translation (HRT) scan scheme for in vivo animal SPECT imaging on a stationary scanner". In 2009 IEEE Nuclear Science Symposium and Medical Imaging Conference (NSS/MIC 2009). IEEE, 2009. http://dx.doi.org/10.1109/nssmic.2009.5401986.
Testo completo