Добірка наукової літератури з теми "Coherence technique"

Thesis (S.M.)--Massachusetts Institute of Technology, Dept. of Mechanical Engineering, 2004.<br>Includes bibliographical references (p. 161-167).<br>Atherosclerosis is an inflammatory disease characterized by an accumulation of lipid and fibrous tissue in the arterial wall. Postmortem studies have characterized rupture-prone atherosclerotic plaques by the presence of a large lipid-rich core covered by a thin fibrous cap. Studies employing finite element analysis (FEA) based on ex vivo plaque geometry have found that most plaques rupture at sites of high circumferential stress, thus diagnosis of plaque vulnerability may be enhanced by probing the mechanical behavior of individual plaques. Elastography is a method of strain imaging in which an image sequence of the artery undergoing deformation is acquired, pixel motion is estimated between each frame, and the resulting velocity field is used to calculate strain. In this thesis, optical coherence tomography (OCT), a high-resolution optical imaging modality, is investigated as a basis for FEA and elastography of atherosclerotic plaques. FEA was performed using plaque geometries derived from both histology and OCT images of the same plaque. Patterns of mechanical stress and strain distributions computed from OCT-based models were compared with those from histology-based models, the current gold standard for FEA. The results indicate that the vascular structure and composition determined by OCT provides an adequate basis for investigating the biomechanical factors relevant to atherosclerosis. A new variational algorithm was developed for OCT elastography that improves upon the conventional algorithm by incorporating strain smoothness and incompressibility constraints into the estimation algorithm.<br>(cont.) In simulated OCT images, the variational algorithm offers significant improvement in velocity and strain accuracy over the conventional algorithm, particularly in the presence of image noise. Polyvinyl alcohol (PVA) phantoms of homogeneous and heterogeneous elastic modulus distribution were developed for further testing of the variational algorithm. Testing with the phantoms indicated that motion- and strain-induced decorrelation between images presents a practical challenge to the implementation of OCT elastography. Analysis of the experimental results led to the identification of potential improvements to the elastography algorithm that may increase accuracy. These improvements may include relaxation of the strain smoothness constraint to incorporate strain discontinuities at boundaries of elastic modulus in heterogeneous regions, and enforcement of geometry compatibility to prevent the estimation of non-physical velocity fields.<br>by Alexandra H. Chau.<br>S.M.

Abstract The development of a non-invasive glucose monitoring technique is very important because it would tremendously diminish the need to puncture the skin when taking blood samples and help diabetic patients in controlling their blood glucose levels and in treating Diabetes Mellitus. The focus of this thesis is on measuring the effect of glucose on the light scattering properties of a tissue-simulating phantom and biological tissues in vitro. Optical coherence tomography (OCT), the pulsed photoacoustic (PA) technique, and the time-of-flight (TOF) technique are used in the measurements and their capabilities for detecting changes in the scattering properties are evaluated and compared with each other. The theoretical background of the techniques, light propagation and PA wave generation are briefly explained. The glucose-induced changes in light scattering are also reviewed. The measurement results with the OCT and the PA technique from Intralipid, pig whole blood, and mouse skin tissue samples show that the glucose-induced changes are larger in the biological tissues than in the Intralipid phantom. The PA measurements show that although the PA signals are stronger at a wavelength of 532 nm than at 1064 nm, the glucose-induced change in the peak-to-peak value of the PA signal measured from pig whole blood is larger at a wavelength of 1064 nm than at 532 nm. The TOF measurements with a streak camera show that the scattering-related changes in the registered pulse shapes occur mainly in the rising part of the pulses. The utilization of fiber-optic measurement heads enabled the detection of back-scattered photons at different distances from the emitting fiber. Although all the techniques are able to detect changes induced by large glucose concentrations (0–5000 mg/dl) in Intralipid, the effect of glucose on the scattering properties of Intralipid is so weak that the techniques failed to detect changes with lower (50–500 mg/dl) concentrations. The measurements of biological samples with the PA technique and with the OCT also demonstrate capabilities to measure glucose concentrations in the physiologically relevant range (18–450 mg/dl) as well. The results compare well with earlier literature and also confirm some earlier findings.

My harmonic approach is founded on two premises, pertaining especially to chordal spacing. First, that for each of the 4,096 possible sets of pitch-classes within equal temperament, without exception, certain spacing principles and techniques, if consistently applied, will generate clear, or relatively clear chordal roots. Typically, the resulting sonorities will possess more than one root – that is, be heard as polychords. Second, that one may control the level of inherent sensory dissonance of any given set of pitch-classes, presented as a chord, through register. These two factors combine to induce both harmonic coherence and euphony. For most listeners, rightly or wrongly, these are not qualities normally associated with music written using the 4,096 – that is, ostensibly ‘atonal', ‘non-tonal' or ‘post-tonal' music. Through my harmonic method, since chordal roots are consistently clarified, one may compose progressions of chordal roots – an asset on which the coherence of diatonic tonality also fundamentally depends. Within a non-diatonic context, the expressive and technical consequences are far-reaching. The following textual commentary demonstrates all of the above, supported by analyses of numerous musical extracts. These are drawn primarily from four of the compositions included in the portfolio – Madame de Meuron, The Art of Thinking Clearly, Velvet Revolution and Nevermore.

L'activite de conception donne naissance a tous les objets qui nous entourent: les voitures, les batiments, les ordinateurs. . . Cette these vise l'automatisation du processus de conception preliminaire d'objets industriels (artefacts). Le modele computationnel de conception par assemblage que nous avons elabore s'execute en trois phases. La premiere analyse l'ensemble des specifications pour y detecter les points delicats et completer les valeurs manquantes. La seconde phase applique un modele de decomposition/combinaison pour construire un artefact de performances proches des specifications. La troisieme phase applique un modele de reconception transformationnelle pour l'ameliorer en vue d'obtenir un artefact repondant aux specifications. Nous proposons dans cette these de combiner trois types de techniques d'intelligence artificielle: (1) un systeme expert pour conseiller des pistes de solution, (2) un systeme de propagation de contraintes pour expliciter leurs consequences afin d'anticiper les conflits et de tirer parti d'interactions entre parties de la solution, et (3) un systeme de maintien de coherence pour resoudre les conflits au sein de la solution dus a l'incoherence et/ou incompletude des connaissances expertes. Ces principes sont mis en uvre dans le systeme smack d'aide a la conception preliminaire d'equipements electroniques de satellites

Les techniques de référence à rang réduit sont couramment employées pour résoudre les problèmes d’extraction de source et de resynchronisation de champs physiques, lorsque le nombre de références dépasse celui des sources incohérentes. Dans ce cas, la matrice croisée-spectrale devient mal conditionnée, rendant la solution des moindres carrés invalide. Bien que la décomposition en valeurs singulières tronquée (DVST) soit utilisée pour résoudre ce problème, elle n'est valable que pour un bruit scalaire sur les références. De plus, il est difficile de définir un seuil de troncature lorsque les valeurs singulières diminuent progressivement. Cette thèse propose une solution nommée technique de référence maximale-coherent (RMC), basée sur la recherche d’un ensemble de références virtuelles maximales correlées avec les mesures de champ. Cette technique est optimale, surtout en présence d’un bruit corrélé sur la référence. Cependant, elle nécessite également une troncature des valeurs propres, exigeant la connaissance ou l’estimation préalable du nombre de sources incohérentes, un problème inverse mal posé et peu étudié. La thèse présente trois méthodes d’énumération de sources applicables à toutes les techniques de référence : un test du rapport de vraisemblance contre le modèle saturé, une technique de bootstrap paramétrique et une approche de validation croisée. Une étude comparative basée sur des données numériques et expérimentales montre deux résultats importants. D'abord, le nombre de fenêtres spectrales utilisées affecte grandement la performance des trois méthodes, qui se comportent différemment selon ce nombre. Ensuite, le bootstrap paramétrique s’avère être la meilleure méthode en termes de précision et de robustesse par rapport au nombre de fenêtres utilisées. Enfin, la technique RMC accompagnée de bootstrap a été utilisée pour l’extraction de source et la resynchronisation de données réelles provenant d’expériences en laboratoire et d’un moteur électrique, fournissant de meilleurs résultats que la solution des moindres carrés et la DVST dans les mêmes conditions<br>Rank-reduced reference/coherence techniques based on the use of references, i.e. fixed sensors, are widely used to solve the two equivalent problems of source extraction and resynchronization encountered during remote sensing of physical fields, when the number of references surpasses the number of incoherent sources. In such case, the cross-spectral matrix (CSM) becomes ill-conditioned, resulting in the invalidity of the least squares LS solution. Although the truncated singular value decomposition (TSVD) was successfully applied in the literature to solve this problem, its validity is limited only to the case of scalar noise on the references. It is also very difficult to define a threshold, for truncation, when the singular values are gradually decreasing. This thesis proposes a solution based on finding a set of virtual references that is maximally correlated with the field measurements, named the maximally-coherent reference (MCR) Technique. This solution is optimal, especially, in the case of correlated noise on the reference, where TSVD fails. However the technique also includes an eigenvalue truncation step, similar to the one required for the TSVD, which necessitates a priori knowledge or the estimation of the number of incoherent sources, i.e. source enumeration, which is an ill-posed inverse problem, insufficiently investigated in the literature within the framework of reference techniques. In this thesis, after providing a unified formalism for all the reference techniques in the literature, three alternative source enumeration methods, applicable to all the reference techniques, were presented namely; a direct likelihood ratio test (LRT) against the saturated model, a parametric bootstrap technique and a cross-validation approach. A comparative study is performed among the three methods, based on simulated numerical data, real sound experimental data, and real electrical motor data. The results showed two important outcomes. The first is that the number of snapshots (spectral windows), used in the spectral analysis, greatly affects the performance of the three methods, and that, they behave differently for the same number of used snapshots. The second is that parametric bootstrapping turned out to be the best method in terms of both estimation accuracy and robustness with regard to the used number of snapshots. Finally, the MCR technique accompanied with bootstrapping was employed for source extraction and resynchronization of real data from laboratory experiments, and an e-motor, and it returned better results than the LS solution and the TSVD when employed for the same purpose

Future wireless network may consist of a cluster of low-complexity battery-powered nodes or mobile stations (MS). Information is propagated from one location in the network to another by cooperation and relaying. Due to the channel fading or node failure, one or more relaying links could become unreliable during multiple-hop relaying. Inspired by conventional multiple-input multiple-output (MIMO) techniques exploiting multiple co-located transmit antennas to introduce temporal and spatial diversity, the error performance and robustness against channel fading of a multiple-hop cooperative network could be significantly improved by creating a virtual antenna array (VAA) with various distributed MIMO techniques. In this thesis, we concentrate on the low-complexity distributed MIMO designed for both coherent and non-coherent diversity signal reception at the destination node. Further improvement on the network throughput as well as spectral efficiency could be achieved by extending the concept of unidirectional relaying to bidirectional cooperative communication. Physical-layer network coding (PLNC) assisted distributed space-time block coding (STBC) scheme as well as non-coherent PLNC aided distributed differential STBC system are proposed. It is confirmed by the theoretical analysis that both approaches have the potential for offering full spatial diversity gain. 　　 Furthermore, differential encoding and non-coherent detection techniques are generally associated with performance degradation due to the doubled noise variance. More importantly, conventional differential schemes suffer from the incapability of recovering the source information in time-varying channels owing to the assumption of static channel model used in the derivation of non-coherent detection algorithm. Several low-complexity solutions are proposed and studied in this thesis, which are able to compensate the performance loss caused by non-coherent detection and guarantee the reliable recovery of information in applications with high mobility. A substantial amount of iteration gain is achieved by combining the differential encoding with error-correction code and sufficient interleaving, which allows iterative possessing at the receiver.

L'objectif de ce travail de recherche est le développement d'un système fibré d'imagerie point par point d'auto fluorescence multi-excitation, de tissus biologiques en utilisant la technique de fluorescence hyperspectrale et l'étude d'un système de tomographie optique cohérente comme possible modalité supplémentaire. La première partie de ce rapport présente les propriétés optique des tissus biologiques et les fluorophores pertinents pour la détection de tumeurs cancéreuses. La deuxième partie présente l'instrumentation du système d'imagerie de fluorescence et l'analyse hyperspectrale des résultats obtenus in vitro.Il est démontré la pertinence de ce type d'analyse qui permet de déterminer la concentration de certains fluorophores. La troisième partie présente le système de tomographie optique cohérente appelé "scan free" OCT car il permet de réaliser des images sans déplacement d'éléments optiques. Ce système est caractérisé et présente des fonctionnalités intéressantes comme la compensation de la dispersion dépendante de la profondeur. Les divers résultats obtenus montrent que ces deux techniques sont complémentaires car elles apportent des informations de nature différentes. La première technique donne de se informations sur la composition biochimique des tissus, la seconde donne des information sur la structure<br>The aim of this activity is the development of a mono point imaging fiber system which uses hyperspectral multi-excitation auto fluorescence technique for biological tissues and the study of an Optical Coherence Tomography system like another modality. At first, this report presents the optical properties of biological tissues and the relevant fluorophores for cancerous tumors detection. Secondly, the fluorescence imaging system instrumentation and hyperspectral analysis are presented with in vitro results. The third part presents the "scan free" optical coherence tomography system which is able to image without optical displacement. It's characterized and have interesting functionality like depth dependant dispersion compensation. These both techniques are complementary because they get different kind of information. The information of the first one is about biochemical composition of the tissues and the information of the second one is about the stucture