Academic literature on the topic 'Bivalentní zdroj'

Diploma thesis deals with change of heating source for a block of flats with aim to reduce heating costs. Thesis contains calculations of energy requirements of house, including requirements for heating and domestic hot water preparation. Several ways of heating by a heat pump were designed based on the calculated values. Each variant of the designed heating system is compared with current operational costs. Possible cost economies and maximum value of investment costs of the heating system were assessed

The thesis is engaged in complete reconstruction of a heat system of a family house with higher heat loss, i.e. heat source, piping and radiators. As a heat source is chosen air-water heat pump. Heat system is designed with panel radiators with regard to minimum building interventions. A required power for hot water heating is calculated and selected a heat pump from suitable power range in combination with storage tank with hot water tank. The bivalent point is determined, as backup source are heating elements installed in storage tank. Drawings and circuit diagrams with safety elements are attached. In the end is calculation of estimated return.

The aim of this thesis is to design the heating system for the house, including the design and calculating the required quantity of heat for hot water. The specified heat sources are the heat pump air to water and solid fuel boiler. The task was to design the heating system to the fastest possible return on investment. The initial investment in a heat pump is high so it is necessary to design the heating system as efficiently as possible. The thesis contains a complete project of calculating heat loss of the building, the design of heating surfaces and their heat-technical calculation. There is included the design of the pipe system, the calculation of pressure loss and its regulation. The thesis also includes design of safety equipment, temperature regulation and drawings. On the basis of calculated data was processed economic assessment, which determines the return on investment to the heat pump. Compared to the gas condensing boiler the return on investment will ideally be after five years.

The master’s thesis contains design for heat insulation of a family house for purpose of reducing the heat loss, adding a new room and complete design of heating system. First part is introducing the house, followed by calculating the heat loss for the original building. Next step proposes the heat insulation of constructions, design for the new room and recalculating the modified heat loss including comparison with the original values. Another part is dealing with the design of the heating system, providing calculations of the power requirement and the pressure loss of underfloor heating and panel radiators. After that there was the selection of the heat pump, bivalent heat source, choice of storage tank and solution for domestic water heating. In the last part the security components were checked, drawing documentation were created and attached and the calculation of return on investment was made.

The diploma thesis deals with overall reduction of energy use in the family house by reducing heat loss and selecting heat and cold source. In the first part are described different types of heat loss along with ways to efectively reduce each loss. Contact insulation systems are further more described, because of beeing used more often. Newer materials are also presented to readers, although their use is less common. The next chapters describe the parameters of choosed heat and cold sources. The calculating part describes process of annual power usage calculation. Further there are three designs of thermal insulation proposed and for each one the appropriate heat and cold source is selected, using heat pump with bivalent operation for all designs. Finally these options are compared in an economic and technical way and the most advantageous of them is determined.